There are two options for using the PICkit 3 depending on how you are powering your hardware:
Please note that the PICkit 2 was never designed to work with the newer devices and although it is known to work, you may cause damage to your PIC devices by using incorrect VPP programming voltages etc as supplied by the PICkit 2.
#HOW TO USE PICKIT 3 HOW TO#
B$(appdir)tools\PICkit2\ -PPIC$(chip) -F$(target).hex -M -A5 -RÄetails on how to upgrade your PICkit 2 to work with new targets are available from here. cs 2 -chip PIC$(chip:u) -nogui "$(outdir)$(target).hex" PPP is the older programming software from Flowcode v5 and previous and can be used to talk to versions of the E-blocks EB006 up to and including version 8. Take care to ensure you only edit the values in the Programmer tab.
MLoader is the default programming software and can be used to talk to the various Matrix hardware including E-blocks, E-blocks2, Formula Flowcode, ECIO, MIAC, ProtoBoard, ProjectBoard. If you do edit the values in the compiler or linker tab then you can simply revert back to the default settings and start again. The settings below are for the Programmer tab of the compiler options. Editing the Compiler or Linker tabs of the compiler options will likely stop Flowcode from being able to compile correctly unless you know what you are doing.